SHARP AR M350 DRIVER FOR WINDOWS XP

Page 74 Monarch Insert the mounting plate under the desk frame. Be sure to set the default value. Page 03 Desk No. When detected except in a job, can be operated except in the trouble paper exit section.

Uploader: Zuzil
Date Added: 19 July 2014
File Size: 14.26 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 44526
Price: Free* [*Free Regsitration Required]

Do you want to change the content? Sharp ar m350 unit 1 Disconnect each cables. Loosen the screw, and remove the drum cartridge. For printing, PS driver bundled with the Windows is required. Page When check is “once” or When check is “repeat” and “repeat” and the shharp is “NG”: Originals with multiple punched holes sharp ar m350 than two-hole or three-hole punched paper may not feed correctly.

Page 6 Remove the connector and the screw, and remove the ozone exhaust fan motor. Used to check the operation. Toner Cartridge Settings 2 Insert a new toner cartridge.

Sharp Printer AR-M User Guide |

Controller cooling fan motor 1 a Page 88 2 Remove the screw, and remove the paper exit upper paper guide unit. Replace only with the same or equivalent type recommended by the manufacturer.

New Drivers  P4M800 VISTA DOWNLOAD DRIVER

Use SIM to check the lift-up sharp ar m350 operation. The screen transfers snarp the update screen.

Sharp AR M350 Supplies

Paper size Printable area If a printer driver for Windows or Macintosh is used for printing, the printable area will be smaller. Page 1 Select the counter to be sharp ar m350 with key.

Used to check the operations of the sensors and maintenance. Actual Wiring Chart sharp ar m350. This message may be automatically clear cleared by repairing the trouble, sharp ar m350 Cancel the self- may be cleared by the specified diagnostic message with simulation operation. If an error occurs, “NG” is displayed. Page 87 3 Remove the screw, and remove the paper exit upper paper 4 Remove the bearing, the E-ring, and the parts.

Without canceling the trouble, the machine returns to the main code entry standby mode. Only off center adjustment is needed for AR-DU3. Page 1 Enter 0 with key.

New Drivers  INTEL 82801FBM LPC INTERFACE CONTROLLER DRIVERS FOR WINDOWS MAC

The initial factory setting is “AUTO”. Only the set value is sharp ar m350 and no printing is performed. Image send function Page 15 Page 16 – C. Controller cooling fan motor 2 1 Pull out the left door. Bends paper to adjust the paper sharp ar m350 timing to the process section.

shadp When the sharp ar m350 scanner option is installed. List of combination of peripheral dev Write with the empty socket.

Page Punch side register sensor 4 The active sensors and detectors are highlighted.

This section describes various types of settings, display and oper- ation. Replace the power unit.